Chief SSM161 User Manual
Displayed below is the user manual for SSM161 by Chief which is a product in the Projector Mount Accessories category. This manual has pages.
Related Manuals
INSTALLATION INSTRUCTIONS
Milestone AV Tec hnol ogie s, and its affiliated co rpo rat ions a nd subs idiaries (c ol lectiv el y, "Miles tone"), intend to make this ma nual ac cu rat e an d compl ete. However, Mi lestone makes
no claim that the in for mation con taine d h erein co vers all deta ils, con ditions or va ri atio ns, nor does i t provide for every pos sible contingency in connection with the installation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone as sumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Chief Manufacturing, a products division of Milestone AV Technologies
8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
8802-0 0022 9 R ev 01
©2009 Mil eston e AV Technologies,
a Ducho ssois Group Comp any
05/09
SSB-161, SSM-161, SLB-161 and SLM-161 Interface Brackets
SSB-161, SSM-161, SLB-161 and SLM-161 Interface Brackets are designed for use with Chief® Series Projector Mounts. See the specific
ins tall ation inst ru ction s prov ide d with the m ount for addi tiona l i nstal lati on in form ation . Unpack carton and ver i fy kit c onte nts. If any l is ted pa rts
are missing, immediately contact a Chief Customer Service representative.
WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
Installation Instructions
WARNING: OVERTIGHTENING OF SCREWS CAN DAMAGE P ART S AND LEAD TO SERIOUS PERSONAL INJURY AND DAMAGE
TO EQUIPMENT! DO NOT over tighten scr ews when installing interface bracket.
NOTE: Step 1 is only required when installing an SLB/SSB interface bracket. If an SLM/SSM bracket is being installed, proceed to step 2.
1. Screw thumb screws onto 10-24 x 5/8" Phillips pan head screws. DO NOT fully tighten thumb screws at this time.
2. Turn projector upside down.
3. Un screw two rear adjust able fee t of projector.
4. Install two rubber bumpers from inside pushing out into two larger holes of brackets (A) and (B).
5. Slide bracket (B) around projector w ith back mounting slot between foot and bottom of p rojector to prevent project or from sliding forwar d
or backward.
6. Slide bracket (A) around opposite side of projector from bracket (B) with back mounting slot between foot and bottom of projector to
preventing projector from sliding forward or backward.
7. Align two slotted holes in bracket (B) with two threaded holes in bracket (A) until brackets touch side of projector.
8. Secure two brackets to projector using 10-24 x 1/4" Phillips pan head screws. Tighten all fasteners at this time, securing the bracket to
the project or.
NOTE: Security screws can be substituted when mounting interface bracket to projector by using the parts and installation
instructions in the All-Points Security Kit.
Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.
(1) Bracket (A)(2) Screw, Phillips pan head, machine, 10-24 x 1/4"
(1) Bracket (B)(2) Rubber Bumper
(4) 10-24 Thumb Nuts ** (1) All-Points Security Kit
**Only used when installing SLB/SSB interface brackets. ****Used when mounting surface of projector is recessed.
NOTE: Specific to SSB-style and SSM-style interface bracket installation, all appropriate screws come pre-installed as reflected in the
encirc led locati ons abov e. DO NOT attempt t o subst itute a nd USE ONLY thi s pre-in stalled hardware for SSB-sty le and SSM-st yle
interface bracket installation.
SLB-161 SLM-161
Towards front of
projector
Towards front of
projector
(Note: SSM-style interface bracket connections
a
r
e
e
n
c
i
r
c
l
e
d
)
(
Note: SSB-style interface bracket connections
a
r
e
e
n
c
i
r
c
l
e
d
)
()
A
()
B
()
B
()
A