Interline 42250005 User Manual
Displayed below is the user manual for 42250005 by Interline which is a product in the Infrared Saunas category. This manual has pages.
Related Manuals
User's manual
EN
Sauna Room
1/12
INFRARED SAUNA CARBON 2-Person
2017/09/25
EN
2/12
PREFACE
Thank you very much for purchasing our product.
Please read this manual carefully before assembling and save it afterwards. Please write down the control
box serial number of the cabin as this number will be required in case of repair or order of spare parts.
ATTENTION
Installation and repair should only be done by a qualified electrician!
Check power supply rating and make sure the grounded outlet is correctly connected before installation.
Use original parts only. Do not share the outlet with any other appliances.
When not in use, turn off the cabin's power unit.
Locate your cabin indoors and on a flat, level and dry surface.
DANGER
Heaters shall not be subjected to water spray; shower heads shall not be installed within the infrared cabin.
Covering the radiator causes a fire hazard due to overheating. Do not cover the heaters !
Keep flammable or easily combustible materials/objects (eg.towels) away from the radiator at all times.
Do not touch the radiator during and shortly after use as a burning hazard exists due to hot parts.
The light bulb heats in use. If the bulb needs to be changed, unplug the cabin and let the bulb cool down
before changing it.
Should the electrical connection get damaged, it must be replaced-either by the manufacturer or by a
licensed electrician!
WARNING
If you suffer from illness or other health-related problems, especially heart conditions or circulatory
disturbances or if you take medication, you should consult a doctor before using the infrared cabin.
Children and frail persons should never be in the cabin without supervision.
If you feel uncomfortable while using the infrared cabin, stop immediately and consult with your doctor.
Never go to a hot infrared cabin if you have taken alcohol, strong medicines or narcotics.
Technical data
Model
Cabin material
Length
Width(depth)
Height
Voltage
Radiators Type
Total output
Back panel
Side panel
Calves
INFRARED SAUNA CARBON 2-Person
Regular hemlock & Thermohemlock
1275 mm
932 mm
1940 mm
230volt 50Hz
Black carbon panel
1800W 7.8A
360W x 2
270W x 2
340W x 1
Floor panel 100W x 2
3/12
PARTS LIST
Cabin Individual parts (variations possible)
2
NO NAME Q'TY
1
3
4
6
8
10
1
1
1
1
1
1
11
1
12
1
13
1
Box No
1
1
2
1
1
2
2
1
2 2 1
5
1 1
9
1 1
2
14
1
7
1 1
Floor panel (1275*932*65mm)
Floor heater (403*334*40mm)
Back panel (1860*1200*43mm)
Side panel 1 (1860*910*43mm)
Bench support panel 1 (465*445*35mm)
Bench support panel 2 (1125*465*40mm)
Back guardrail (1128*868*50mm)
Side guardrail (834*868*50mm)
Bench surface panel (1162*450*33mm)
Side glass (1860*855*8mm)
Front glass 2(1860*612*8mm)
Top panel (1275*932*65mm)
Glass connecting bar/Wood panel for Glass fixing 1 (602*25*20mm)
Glass connecting bar/Wood panel for Glass fixing 2 (817*25*20mm)
EN
12
3
4
5
6
7
8
9
11
10
13
14
12
15
16
17
NO NAME Q'TY Box No
4/12
Cabin Individual parts (variations possible)
1
15
2
Glass door (1796*572*8mm)
2
16
1
Door handle ( 300*40*45mm )
1
17
1
MDF cover (1233*890*3mm)
ASSEMBLE INSTRUCTIONS
Assemble tips
Tools
Spiral drill (kit)
Screwdriver (kit)
Allen Wrench (kit)
Spirit level
Tape measure Electric drill
Cutter
Pencil
Hammer
Stepladder
Hardware parts (variations possible)
19x
Φ4*45
2x
Φ6*60
Please remove transport packaging and inspect that your infrared cabin has been delivered complete and
intact before beginning assemble.
A least 2 persons are required for assemble of the cabin
Please check the countersink and hole diameter of the drill holes to avoid damaging the wood..
The minimum room height required for installation is 2020mm
4x
Φ4*70
1x
10x
Φ4*35 Glass clip
EN
5/12
ASSEMBLE INSTRUCTIONS
(3)
1
2X2
3
Note: connect floor
heater cable
4
4
3
(1)(2)
EN
The top need to be stand at the same line when
connecting the back panel and side panel
4 x (Φ4x60)
(4)
5
6
6/12
ASSEMBLE INSTRUCTIONS
7
7
8
(5)
(6)
EN
10 x
5 x
(Φ4x45)
(Φ4x45)
Front glass
8X2
9X2
7/12
ASSEMBLE INSTRUCTIONS
EN
10
2 x
4 x
(Φ4x45)
(Φ4x45)
11
Note: connect calves
heater cable
12
X 4
4 X
(Φ4x45)
(Φ4x45)
Note: connect side heater
cable; side heater distance
away from floor panel about
520mm.
Note: connect back heater
cable; back heater distance
away from floor panel about
520mm.
Note: connect side
heater cable Note: connect side
heater cable
13
(7) (8)
(9)(10)
8/12
ASSEMBLE INSTRUCTIONS
EN
14
17
15
16 Glass clip
Hinge surface
Rubber fitting
Glass door
Hinge bottom
Rubber fitting
Hex screw
Hinge surface
Rubber fitting
Glass door
Hinge bottom
Rubber fitting
Hex screw
Note: connect all cables on the roof of the cabin
（Φ6x60)
Wood cover 2 x
(11)
(12)
9/12
To Heater
AC230V/15A
MAX:10A/1PCS
Power box
Temperature
Sensor
Mp3
Antenna Speaker
4Ω/3W
4Ω/3W
OUTPUT DC12V/3A
INPUT AC230V
Color light
DC12V/8W
105°C
Temperature Control
AC230V/340W
AC230V/340W
AC230V/100W
AC230V/100W
AC230V/270W
FKF-603
Input Voltage
Power Rating
Current Rating
Safety Grade
Model
I
7.8A
1800W
AC230V/50HZ
CIRCUIT DIAGRAM
AC230V/270W
AC230V/360W
EN
OPERATING INSTRUCTIONS
4)Color light
Short press ,you can set the desired color(7 color totally)and close the light; Long press to go
into an automatically cycling mode,changing 7 colors every 5 seconds.
Connect the power unit to wall outlet, the LED indicator will start to blink on the display.
Now it is possible to switch on the infrared heaters, the light and the music function.
Color light
Time setting
Temperature setting
Time/Temperature+/ +
Time/Temperature-/ -
ON/OFF
1)Startup
Press to switch on the display and heaters start to work, the length of time is automatically set to 99 minutes
and the air temperature inside the cabin will be presented. Press again could switch off the heaters.
2)Temperature settings
The left display refers to the air temperature. Press , you can set the desired temperature from 35℃ to 60℃
by pressing the / keys,Interval=1℃; The setting number blinks 10 seconds then automatically presents
the air temperature; When at this temperature, the heaters will stop working automatically; When it fall 2℃
below this temperature, the cabin will start up automatically.
Please note: The maximum air temperature reachable in the cabin may be lower than the desired
temperature. This is dependent on the temperature outside the cabin. Default temperature=40℃
5)Mp3 player
10/12
EN
3)Time settings
The right display refers to the length of time. Press , you can set the desired time from 5mins to 99mins
by pressing the / keys; Interval=1mins;
When count down to 00, the heaters will shut off automatically.
Default time=99minutes.
USB/SD or Bluetooth mode:
You can select songs by short pressing the / keys and adjust the volume (0-32) by long pressing
the / keys. The key for pause.
FM radio mode:
Long press to search stations (87.5MHZ-108MHZ) automatically, the system will save all of them;
You can select stations by short pressing the / keys and adjust the volume (0-32) by long pressing
the / keys.
ActivatetheMP3playerbypressingandholdingthe" ” buttonontheMP3player.Selectthe
preferredmodewithbrief repeatedpressesofthe" "buttonontheMP3 player.(USB,MMCCARD,
Bluetooth,FMradio)
SERVICE
Use instructions
Drink plenty of liquids before and after use of the infrared cabin.
Dry yourself off completely.
The optimal cabin temperature for a pleasant session lies between 35 and 60℃.
After a heating period of an hour at the latest, the cabin should be switched off and a heating brake of
at least 30 minutes should be taken.
Maintenance instructions
Clean the cabin with a damp cotton towel, dry with a clean dry towel.
Clean the glass with a window/glass cleaner and a soft cloth.
Do not pour water in the control panel or clean it with wet cloth. For cleaning purposes, use a cleaning
cloth that has been only slightly moistened with a mild soapy solvent (dish detergent).
Do not use chemical detergents to clean the cabin.
Please fasten the screws of the bench once every three months, avoid the loose or drop off.
11/12
It is recommended to take a warm shower and relax after use.
Notes:
EN
SERVICE
Fill in this form and make a picture of it and Email to:
Date of purchase:
Serial Number:
Reference number:
Name:
Article state (unopened, just opened or used):
Please encircle on picture below which heater or which panel
has a fault.
Attach pictures of the problem and send them through email.
Control unit label
GUARANTEE CARD
12/12
EN
12
3
4
5
6
7
8
9
11
10
13
14
12
15
16
17