Table of Contents
Matrox RMK-19TR-A User Manual
Displayed below is the user manual for RMK-19TR-A by Matrox which is a product in the Rack Accessories category. This manual has pages.
Related Manuals
Matrox Rack Mounting Kit – Release note 1/2
Matrox Rack Mounting Kit – Release note
F20254-401-0110 2018.10.19
These release notes contain important information about your Matrox product. These notes are
available in English only. We apologize for any inconvenience this may cause.
Rack mount kit
Hardware supplied
A rack mount kit for your Matrox product includes:
Mounting shelf (19 in / 48.26 cm)
Head screws (4× 10-32, 4× 12-24)
Flat-head screws (4× 6 mm M3)
Mounting guidelines
To prevent damage to your Matrox hardware, read the following guidelines before mounting your
Matrox hardware:
To install your mounting shelf, fasten it to the rack as per your rack’s instructions. Head
screws compatible with most rack mounts are provided.
Use a hand screwdriver to carefully tighten each screw. Make sure not to overtighten the
screws.
Don’t stack anything directly over the device.
Make sure the cables connected to your device are properly secured and that no tension
is applied to them.
Make sure the ambient temperature doesn’t exceed the maximum recommended
temperatures. For more information, see the “Product information” section of your user
guide.
Once your device is mounted, you can connect your system, monitors, and devices to your Matrox
device.
2/2 Matrox Rack Mounting Kit – Release note
Mounting your Matrox devices
You can mount two (2) devices horizontally on a single shelf.
To mount your device, use the following guidelines:
Your device has two (2) mounting holes under its casing. Use two (2) 6 mm M3 flat-head
screws (included in the kit) to secure each device. You need to remove the four (4) rubber
pads under your device before you can secure your device to the shelf.
Mounting shelf – Underside
Mounting shelf – Front
Product
Mounting holes
Label Distance from the front edge
Maevex 6020, 6120
& 6150
M/E 3.15 in / 8.00 cm
Extio N3208 & N3408 M/E 3.15 in / 8.00 cm
Avio A
A/MDG
Device facing forward – 3.49 in / 8.86 cm
Device facing backward – 2.15 in / 5.46 cm