Table of Contents
Philips AEA1000/37 User Manual
Displayed below is the user manual for AEA1000/37 by Philips which is a product in the RFID Tags category. This manual has pages.
Related Manuals
www.philips.com/welcome
User manual
Always there to help you
Register your product and get support at
AEA1000
Question?
Contact
Philips
1
English
EN
Contents
Contents
1 Important 2
Important safety information 2
Notice 3
2 Your InRange device 5
Introduction 5
What’s in the box 5
Your InRange device 5
3 Prepare 6
Prepare your iPhone 4S/iPhone 5 or
New iPad 6
Prepare the InRange device 6
Set up Bluetooth connection 7
4 Use 9
Locate your iPhone 4S/iPhone 5/New
iPad or InRange device 9
Alert you when your iPhone 4S/
iPhone 5/New iPad and InRange
device are out of range 10
Set safe range free of alerts 10
5 Product information 11
6 Troubleshooting 12
2EN
1 Important
Important safety information
The translation of this document is for
reference only.
In the event of any inconsistency between the
English version and the translated version, the
English version takes precedence.
Caution
•RISK OF EXPLOSION IF THE BATTERY IS REPLACED
BY AN INCORRECT TYPE.
•DISPOSE OF USED BATTERIES ACCORDING TO
THE INSTRUCTIONS.
•To avoid damage or malfunction:
•Do not expose the device to excessive heat caused by
heating equipment or direct sunlight.
•Do not drop the device or allow objects to fall on the
device.
•Do not allow the device to be submerged in water.
Do not expose the battery compartment to water, as
water entering the device may cause major damage.
•Active mobile phones in the vicinity may cause
interference.
•Do not use any cleaning agents containing alcohol,
ammonia, benzene, or abrasives as these may harm the
device.
• Referallservicingtoqualiedservice
personnel. Servicing is required when the
device has been damaged in any way, such
as objects have fallen into the device or
the device does not operate normally.
• The device shall not be exposed to
dripping or splashing.
• Do not place any sources of danger on the
device (e.g. lighted candles).
• The small parts of this device can
potentially be swallowed by babies or small
children. Keep these parts out of reach of
children.
About operating and storage temperatures
• Operate in a place where temperature is
always between 0 and 35ºC (32 to 95ºF)
• Store in a place where temperature is
always between -20 and 45ºC (-4 to
113ºF).
• Battery life may be shortened in low
temperature conditions.
About replacement of parts/
accessories
Visit www.philips.com/support to order
replacement parts/accessories.
Risk of swallowing batteries!
• The device may contain a coin/button
type battery, which can potentially be
swallowed. Keep the battery out of reach
of children at all times! If swallowed, the
battery can cause serious injury or death.
Severe internal burns can occur within two
hours of ingestion.
• If you suspect that a battery has been
swallowed or placed inside any part of the
body, seek immediate medical attention.
• When you change the batteries, always
keep all new and used batteries out of
reach of children. Make sure that the
battery compartment is completely secure
after you replace the battery.
• If the battery compartment cannot be
completely secured, discontinue use of the
product. Keep out of reach of children and
contact the manufacturer.
Anychangesormodicationsmadetothis
device that are not expressly approved by
Philips Consumer Lifestyle may void the user’s
authority to operate the equipment.
3
English
EN
Notice
Notice of compliance
The device complies with Part 15 of the FCC
Rules, and and Industry Canada licence-exempt
RSS standard(s). Operation is subject to the
following two conditions:
1) This device may not cause harmful
interference, and
2) This device must accept any interference
received, including interference that may cause
undesired operation.
FCC rules
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy
and, if not installed and used in accordance
with the instruction manual, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the
equipment off and on, the user is encouraged
to try to correct the interference by one or
more of the following measures:
• Relocate the receiving antenna.
• Increase the separation between
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
Radiation Exposure Statement
This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment. This equipment should be installed
and operated with a minimum distance of
20cm between the radiator and your body.
This transmitter must not be co-located or
operated in conjunction with any other antenna
or transmitter.
This equipment also complies with Industry
Canada RSS-102 with respect to Canada’s
Health Code 6 for Exposure of Humans to RF
Fields.
IEEE 802.11b, 802.11g or 802.11n operation of
thisproductintheU.S.A.isrmware-limitedto
channels 1 through 11.
Warning:1)Anychangesormodications
not expressly approved by the manufacturer
could void the user’s authority to operate
the equipment. 2) The manufacturer is not
responsible for any radio or TV interference
causedbyunauthorizedmodicationstothis
equipment.Suchmodicationscouldvoidthe
user’s authority to operate the equipment.
Model number: PHILIPS AEA1000/00
Trade Name: Philips
Responsible Party: Philips, P.O. Box 10313
Stamford, CT 06904
Canada
This device complies with Industry Canada
licence-exempt RSS standard(s): Operation
is subject to the following Two conditions: (1)
this device may not cause interference, and
(2) this device must accept any interference,
including interference that may cause undesired
operation of the device.
Radio interference
This Class B digital apparatus complies with
Canadian ICES-003.
4EN
Disposal of your old product and
battery
Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused.
Never dispose of your product with other
household waste. Please inform yourself about
the local rules on the separate collection of
electrical and electronic products and batteries.
The correct disposal of these products helps
prevent potentially negative consequences on
the environment and human health.
Your product contains batteries, which cannot
be disposed of with normal household waste.
Please inform yourself about the local rules on
separate collection of batteries. The correct
disposal of batteries helps prevent potentially
negative consequences on the environment and
human health.
Please visit www.recycle.philips.com for
additional information on a recycling center in
your area.
Environmental information
All unnecessary packaging has been omitted.
We have tried to make the packaging easy to
separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene
(bags, protective foam sheet.)
Your system consists of materials which can
be recycled and reused if disassembled by
a specialized company. Please observe the
local regulations regarding the disposal of
packaging materials, exhausted batteries and old
equipment.
The Bluetooth® word mark and logos are
registered trademarks owned by Bluetooth
SIG, Inc. and any use of such marks by Philips is
under license.
Disclaimer
Philips is not responsible for any loss of
valuables.
5
English
EN
2 Your InRange
device
TofullybenetfromthesupportthatPhilips
offers, register your product at www.philips.
com/welcome.
Introduction
This InRange device offers you a loss prevention
solution that allows you to:
• locate your iPhone 4S/iPhone 5/New
iPad from the InRange device.
• attach the InRange device to your
valuables and locate them from your
iPhone 4S/iPhone 5/New iPad.
• alert you from the InRange device
when your iPhone 4S/iPhone 5/New
iPad is beyond the set range.
• alert you from your iPhone 4S/iPhone
5/New iPad when your valuables
attached to the InRange device are
beyond the set range.
What’s in the box
Check and identify the contents of your
package:
• InRange device
• Protective pouch
• Metal lock
• Cell battery (CR2016) (for
replacement)
• Battery eject tool
• Lanyard
• Quick start guide
• Safety sheet
Your InRange device
This InRange device is compatible with the
following iPhone and iPad models:
• The New iPad
• iPhone 5
• iPhone 4S
6EN
3 Prepare
TofullybenetfromthesupportthatPhilips
offers, register your product at www.philips.
com/welcome.
Prepare your iPhone 4S/
iPhone 5 or New iPad
1 Enable Bluetooth on your iPhone 4S/
iPhone 5/New iPad.
2 Download and install Philips InRange from
Apple App Store.
InRange
+
Prepare the InRange device
For rst-time use:
• Remove the plastic tab from the battery
compartment.
» The InRange device switches on
automatically.
» Thepowerindicatorashesredand
green alternately, and the InRange
device beeps.
Tip
•To switch off the InRange device, press and hold for
more than 3 seconds until the power indicator turns
off and the InRange device beeps. To switch on it again,
press and hold untilthepowerindicatorashesred
and green and the InRange device beeps.
To replace the battery:
1 Use the supplied metal pin to eject the
battery compartment.
2 Load a CR2016 cell battery with the
correct polarity as indicated.
3 Push to close the battery compartment.
1
2
3
7
English
EN
Set up Bluetooth connection
Note
•Before setup, make sure that you have enabled
Bluetooth on your iPhone 4S/iPhone 5/New iPad, and
thepowerindicatorontheInRangedeviceashesred
and green alternately.
1 Put the InRange device into the protective
pouch, then use the supplied metal lock to
secure the pouch.
2 Attach the InRange device to your
valuables (objects), such as a key or bag.
3 Run Philips InRange on your iPhone 4S/
iPhone 5/New iPad.
4 Tap Get Started.
5 As instructed, make sure that you have
enabled Bluetooth on your iPhone 4S/
iPhone 5/New iPad, then tap Next.
8EN
6 As instructed, make sure that you have
switched on the InRange device, then tap Next.
» The iPhone 4S/iPhone 5/New iPad
starts to scan and search for the
available InRange device.
» After the InRange device is found, ‘Philips
AEA1000’ appears on the app screen.
7 Tap ‘Philips AEA1000’, then tap Pair on the
pop-up message.
» Your iPhone 4S/iPhone 5/New iPad
starts to pair and connect with the
InRange device.
8 After successful connection, tap the
image/name of the object attached to the
InRange device.
• Ifyoucannotndamatchingimage/
name, tap Other, then follow the on-
screen instructions to take a picture
and name your object.
9 Select a safe distance for the object to be
protected, then tap Donetonishsetup.
9
English
EN
4 Use
Locate your iPhone 4S/iPhone
5/New iPad or InRange
device
You can locate your iPhone 4S/iPhone 5/New
iPad or InRange device simply with one touch.
To locate your iPhone 4S/iPhone 5/New iPad:
1 Press on the InRange device.
» Both the InRange device and your
iPhone 4S/iPhone 5/New iPad beep.
2 FollowthebeepstondyouriPhone4S/
iPhone 5/New iPad.
3 Press on the InRange device again or
tap Stop on the popup menu of your
iPhone 4S/iPhone 5/New iPad to stop
beep.
To locate your valuables attached to the
InRange device:
1 Run Philips InRange on your iPhone 4S/
iPhone 5/New iPad, then tap on the
app screen.
» Both the InRange device and your
iPhone 4S/iPhone 5/New iPad beep.
2 FollowthebeepstondtheInRange
device.
3 Press on the InRange device or tap
on the app screen of your iPhone 4S/
iPhone 5/New iPad again to stop beep.
10 EN
Alert you when your iPhone
4S/iPhone 5/New iPad and
InRange device are out of
range
To prevent loss of your iPhone 4S/iPhone 5/
New iPad or your valuables attached to the
InRange device, you can hear beeps when the
InRange device and your iPhone 4S/iPhone 5/
New iPad are out of the set range.
To stop the beeps:
• Follow the beeps and walk around until
your iPhone 4S/iPhone 5/New iPad and
the InRange device return to the set range.
Set safe range free of alerts
You can use the safe range settings to prevent
your iPhone 4S/iPhone 5/New iPad or InRange
device from ringing within a certain range.
1 Run Philips InRange on your iPhone 4S/
iPhone 5/New iPad, then tap .
2 Tap Safe Range -> Add Safe Range.
3 Select a place on the map as your safe
range, then tap Donetonishthesetting.
11
English
EN
5 Product
information
Bluetooth version Bluetooth® smart
Battery CR2016
Battery life 3 months
Product
dimension
59.9x39.9x3.8mm
78.0x44.0x7.9mm (with
pouch)
Weight 10.8g
12 EN
6 Troubleshooting
Warning
•Risk of electric shock. Never remove the casing of the
device.
To keep the warranty valid, never try to repair
the device yourself.
If you have problems using this device, check
the following points before you request service.
If you still have a problem, register your device
and get support at www.philips.com/support.
Failed to set up Bluetooth connection
between my iPhone 4S/iPhone 5/New iPad
and InRange device.
• Tap Rescan on the app screen of Philips
InRange to try again.
• Check whether the InRange device is
switched on and the power indicator
ashesredandgreen.Pressandhold
on the InRange device for more than 3
seconds to switch on the device.
• Check whether you have enabled
Bluetooth on your iPhone 4S/iPhone 5/
New iPad.
Why is that there is no beep when my iPhone
4S/iPhone 5/New iPad and InRange device are
out of range?
• Check whether you have set the safe
range.
• Check whether you have switched off the
InRange device.
• Check whether the battery in the InRange
deice is drained. Replace the battery.
Specifications are subject to change without notice
© 2013 Koninklijke Philips Electronics N.V.
All rights reserved.
AEA1000_UM_37_V3.0