Table of Contents
Philips BT100V/37 User Manual
Displayed below is the user manual for BT100V/37 by Philips which is a product in the Portable Speakers category. This manual has pages.
Related Manuals
www.philips.com/support
BT100
User manual
Always there to help you
Register your product and get support at
Question?
Contact
Philips
1EN
Contents
1 Important 2
Safety 2
Notice 3
2 Your portable speaker 6
Introduction 6
What's in the box 6
Overview of the speaker 7
3 Get started 8
Charge the built-in battery 8
Select a source or turn off 9
4 Use Bluetooth devices 10
Connect a device 10
Play audio via Bluetooth 11
Make a call 12
5 Listen to an external device 13
6 Product information 14
Specications 14
7 Troubleshooting 15
General 15
About Bluetooth device 16
2EN
1 Important
Safety
Important safety instructions
a Read these instructions.
b Keep these instructions.
c Heed all warnings.
d Follow all instructions.
e Do not use this apparatus near water.
f Clean only with dry cloth.
g Do not block any ventilation openings. Install in accordance with the
manufacturer's instructions.
h Do not install near any heat sources such as radiators, heat registers,
stoves, or other apparatus (including ampliers) that produce heat.
i Only use attachments/accessories specied by the manufacturer.
j Refer all servicing to qualied service personnel. Servicing is required
when the apparatus has been damaged in any way, such as liquid has been
spilled or objects have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally, or has been
dropped.
k Apparatus shall not be exposed to dripping or splashing.
l Do not place any sources of danger on the apparatus (e.g. liquid lled
objects, lighted candles).
3EN
m Battery shall not be exposed to excessive heat such as sunshine, re or
the like.
• Perchlorate Material - special handling may apply. See www.dtsc.ca.gov/
hazardouswaste/perchlorate.
• Danger of explosion if battery is incorrectly replaced. Replace only with
the same or equivalent type.
Warning
•Never remove the casing of this apparatus.
•Never lubricate any part of this apparatus.
•Never place this apparatus on other electrical equipment.
Notice
Anychangesormodicationsmadetothisdevicethatarenotexpresslyapproved
by WOOX Innovations may void the user’s authority to operate the equipment.
Notice for the USA and Canada
This device complies with Part 15 of the FCC Rules and RSS standard of Industry
Canada. Operation is subject to the following two conditions:
1 this device may not cause harmful interference, and
2 this device must accept any interference received, including interference that
may cause undesired operation.
4EN
Le présent appareil est conforme aux CNR d’Industrie Canada applicables
aux appareils radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2)
l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d’en compromettre le fonctionnement.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules and ICES-003 of
Industry Canada . These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following
measures:
• Relocate the receiving antenna.
• Increase the separation between equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
RF Radiation Exposure Statement: This equipment complies with FCC’s and
IC’s RF radiation exposure limits set forth for an uncontrolled environment. The
antenna(s) used for this transmitter must be installed and operated to provide a
separation distance of at least 20 cm from all persons and must not be collocated
or operating in conjunction with any other antenna or transmitter. Installers must
ensure that 20cm separation distance will be maintained between the device
(excluding its handset) and users.
Radio interference
This Class B digital apparatus complies with Canadian ICES-003.
5EN
Disposal of your old product and battery
Your product is designed and manufactured with high quality materials and
components, which can be recycled and reused.
This product may contain lead and mercury. Disposal of these materials
may be regulated due to environmental considerations. For disposal or
recycling information, please contact your local authorities or visit www.recycle.
philips.com.
This product contains non-removable batteries:
• Do not incinerate. Batteries may explode if overheated.
• For disposal or recycling information, please contact your local authorities or
visit www.recycle.philips.com.
Always bring your product to a professional to remove the built-in
battery. A
Environmental information
All unnecessary packaging has been omitted. We have tried to make
the packaging easy to separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene (bags, protective foam
sheet.)
Your system consists of materials which can be recycled and reused if disassembled
by a specialized company. Please observe the local regulations regarding the
disposal of packaging materials, exhausted batteries and old equipment
The Bluetooth® word mark and logos are registered trademarks owned by
Bluetooth SIG, Inc. and any use of such marks by WOOX Innovations is under
license.
Note
•The type plate is located on the bottom of the apparatus.
A
6EN
2 Your portable speaker
Congratulationsonyourpurchase,andwelcometoPhilips!Tofullybenetfrom
the support that Philips offers, register your product at www.philips.com/welcome.
Introduction
With this speaker, you can
• listen to audio from an external device via Bluetooth connection,
• listen to audio from an external device through the AUX socket, and
• make phone calls.
What's in the box
Check and identify the contents of your package:
• Main unit
• USB cable
• Short user manual
7EN
Overview of the speaker
a Battery/Bluetooth indicator
• Lightsup,ashesorturnsoffdependingonthestatusofBT100.
• For details, see the following section Charging indicator and Bluetooth
indicator.
b Integrated microphone
c
• Press to answer an incoming call.
• Press to end the current call.
• Press and hold for 3s to reject an incoming call.
• Press and hold for 3s to change call between BT100 and mobile phone.
• In Bluetooth mode, press and hold for 8s to clear the pairing
information.
d DC IN
• Charge BT100 through the USB cable.
e OFF AUX
• Slide to select Bluetooth/AUX IN mode.
• Slide to power off the speaker.
f AUX
• Connect to an external player.
d
c
b
e
f
a
8EN
3 Get started
Always follow the instructions in this chapter in sequence.
Charge the built-in battery
BT100 is powered by a built-in rechargeable battery.
Note
•Before use, fully charge the built-in battery.
Connect the USB cable between
• the DC IN socket on the speaker, and
• a USB socket of a computer.
OFF AUX
9EN
Charging indicator
Indicator Battery
In Bluetooth mode Flashing blue/Solid blue
(depending on the working status)
Under charging
Flashing blue/Solid blue
(depending on the working status)
Fully charged
In AUX IN mode Flashing white Under charging
Solid white Fully charged
In OFF mode Flashing white Under charging
OFF Fully charged
Note
•In Bluetooth mode, when the battery is empty, BT100 turns off automatically. And the Bluetooth
indicatorasheswhitewhilerecharging.ToreturntoBluetoothmode,turnBT100 off and select
Bluetooth mode again.
•The USB socket is for charging only.
Select a source or turn off
Slide the OFF AUX switch to select a source or turn off BT100.
• : Listen to an external Bluetooth device through Bluetooth connection.
• AUX IN: Listen to an external device through an audio input cable.
• OFF: Turn off BT100.
10 EN
4 Use Bluetooth devices
With this speaker, you can listen to audio from a player and make a call through
Bluetooth.
Note
•Make sure that no audio input cable is connected to the AUX socket.
•Philips does not guarantee the compatibility with all Bluetooth devices.
•Before pairing a device with this system, read its user manual for Bluetooth compatibility.
•The product can memorize a maximum of 8 paired devices.
•Make sure that Bluetooth function is enabled on your device, and your device is set as visible to all
other Bluetooth devices.
•Any obstacle between this system and a Bluetooth device can reduce the operational range.
•Keep away from any other electronic device that may cause interference.
Connect a device
1 Switch the slider to .
2 On your Bluetooth device, search for BT100.
3 In the device list, select PHILIPS BT100.
• If a message prompts for the permission for Bluetooth connection with
PHILIPS BT100,conrmit.
• If a password is required, enter 0000andthenconrm.
» BT100 beeps twice when the Bluetooth connection is established.
Bluetooth indicator
The LED indicator on the top indicates the status of Bluetooth connection.
Indicator Bluetooth connection
Flashing blue Connecting or waiting for connection
Solid blue Connected
11EN
Disconnect a device
• On your device, disable the Bluetooth connection with BT100.
• Or, on BT100, press and hold when it is not during a call.
Note
•BeforeconnectinganotherBluetoothdevice,disconnectthecurrentdevicerst.
Reconnect a device
• For a paired Bluetooth device on which the automatic reconnection is
enabled, this product reconnects with it once it is detected.
• For a paired Bluetooth device that does not support the automatic
reconnection, reconnect it with this product manually.
Play audio via Bluetooth
Note
•If there is an incoming call on the connected mobile phone, music play pauses.
Buttons Functions
Press and hold for 8 seconds to clear the Bluetooth pairing information.
12 EN
Make a call
Button functions in Bluetooth mode
Buttons Status Functions
Incoming call Press to answer an incoming call.
Press and hold for more than 3 seconds to reject an
incoming call.
During a call Press to end the current call.
Press and hold for more than 3 seconds to transfer call
between BT100 and the mobile phone.
13EN
5 Listen to an external device
You can also listen to an external audio device, for example, MP3 player, through
BT100.
1 Connect an audio input cable with a 3.5 mm connector on both ends to
• the AUX socket on this product, and
• the headphone socket on the external device.
2 Switch the slider to the AUX position.
3 Play audio on the external device (refer to its user manual).
OFF AUX
OFF AUX
1
2
14 EN
6 Product information
Note
•Product information is subject to change without prior notice.
Specications
Amplier
Rated Output Power 2W RMS
Signal to Noise Ratio >70dB
Aux-in Link 300 mV RMS, 10 kohm
Bluetooth
Bluetoothspecication V3.0 +EDR
SupportedProles HFPv1.5, AD2Pv1.2
Advanced features Echo and noise cancellations
Range 10 m/33 feet line of sight
General information
DC power input USB: 5V, 500mA;
Built-in Li-Polymer battery 3.7V 500mAH
Battery working time >8 hours
Dimensions - Main Unit (L x W x H) 63 x 63 x 82 mm
Weight - Main Unit 0.18 kg
15EN
7 Troubleshooting
Warning
•Never remove the casing of this device.
To keep the warranty valid, never try to repair the system yourself.
If you encounter problems when using this device, check the following points
before requesting service. If the problem remains unsolved, go to the Philips Web
page (www.philips.com/support). When you contact Philips, make sure that the
device is nearby and the model number and serial number are available.
General
No power
• Recharge your speaker.
No sound
•Adjust volume on the connected device.
•When you listen to audio through Bluetooth, make sure that no audio input
cable is connected to the AUX socket.
•Make sure that your Bluetooth device is within the effective operational
range.
No response from the speaker
•Restart the speaker.
16 EN
About Bluetooth device
The audio quality is poor after connection with a Bluetooth-enabled device.
•The Bluetooth reception is poor. Move the device closer to this product or
remove any obstacle between them.
Cannot connect with the device.
•The Bluetooth function of the device is not enabled. Refer to the user
manual of the device for how to enable the function.
•This product is already connected with another Bluetooth-enabled device.
Disconnect that device and then try again.
The paired device connects and disconnects constantly.
•The Bluetooth reception is poor. Move the device closer to this product or
remove any obstacle between them.
•For some devices, Bluetooth connection may be deactivated automatically as
a power-saving feature. This does not indicate any malfunction of this product.
17EN
Specifications are subject to change without notice.
2014 © WOOX Innovations Limited. All rights reserved.Philips
and the Philipsʼ Shield Emblem are registered trademarks of
Koninklijke Philips N.V. and are used by WOOX Innovations
Limited under license from Koninklijke Philips N.V.
BT100_27_37_UM_V2.0