Table of Contents
Philips BT2000B/37 User Manual
Displayed below is the user manual for BT2000B/37 by Philips which is a product in the Portable Speakers category. This manual has pages.
Related Manuals
www.philips.com/support
BT2000
User manual
Always there to help you
Register your product and get support at
Question?
Contact
Philips
1EN
Contents
1 Important 2
Important safety instructions 2
2 Your Bluetooth speaker 3
Introduction 3
What's in the box 3
Overview of the speaker 4
3 Get started 5
Attach the string 5
Charge the built-in battery 5
Turn on/off 5
4 Play 6
Play from Bluetooth devices 6
Play from external devices 6
Fold or unfold the speaker 7
Adjust volume 7
5 Product information 8
Specications 8
6 Troubleshooting 9
General 9
About Bluetooth device 9
7 Notice 10
Care of the environment 10
Trademark notice 11
2EN
1 Important
Warning
• Never remove the casing of this speaker.
• Never lubricate any part of this speaker.
• Never place this speaker on other electrical equipment.
• Keep this speaker away from direct sunlight, naked
amesorheat.
Important safety instructions
a Read these instructions.
b Keep these instructions.
c Heed all warnings.
d Follow all instructions.
e Do not use this apparatus near water.
f Clean only with dry cloth.
g Do not block any ventilation openings.
Install in accordance with the
manufacturer's instructions.
h Do not install near any heat sources such
as radiators, heat registers, stoves, or
other apparatus (including ampliers) that
produce heat.
i Only use attachments/accessories
specied by the manufacturer.
j Refer all servicing to qualied service
personnel. Servicing is required when
the apparatus has been damaged in any
way, such as liquid has been spilled or
objects have fallen into the apparatus, the
apparatus has been exposed to rain or
moisture, does not operate normally, or
has been dropped.
k Battery shall not be exposed to excessive
heat such as sunshine, re or the like.
l Apparatus shall not be exposed to
dripping or splashing.
m Do not place any sources of danger on
the apparatus (e.g. liquid lled objects,
lighted candles).
Note
• The type plate is located on the bottom of the
apparatus.
3EN
2 Your Bluetooth
speaker
Congratulations on your purchase, and
welcometoPhilips!Tofullybenetfromthe
support that Philips offers, register your product
at www.philips.com/welcome.
Introduction
With this speaker, you can enjoy audio from
your Bluetooth-enabled devices, or other
external audio devices.
What's in the box
Check and identify the contents of your
package:
• Speaker
• USB cable for charging
• String for carrying
• User manual
4EN
Overview of the speaker
a DC IN
• Recharge the built-in battery with a
USB cable.
b AUDIO IN
• Connect an external audio device.
c LED indicator
d OFF/AUDIO IN/
• Select Bluetooth or AUDIO IN source.
• Turn the speaker off.
e PAIRING
• Disconnect Bluetooth connection.
• Enter Bluetooth pairing mode.
a
b
cd
e
5EN
3 Get started
Always follow the instructions in this chapter in
sequence.
Attach the string
For easy carrying, attach the supplied string to
this speaker as illustrated.
Charge the built-in battery
The speaker is powered by a built-in
rechargeable battery.
Note
• Before use, fully charge the built-in battery.
• The micro USB socket is for charging only.
• Rechargeable battery has a limited number of charge
cycles. Battery life and number of charge cycles vary by
use and settings.
Connect the supplied USB cable between
• the DC IN socket on the speaker, and
• a USB socket of a computer.
DC IN
Charging indicator status
The LED indicator indicates the battery status.
Under
charging
Fully charged
"OFF"
mode
Flashing white Off
"AUDIO
IN" mode
Flashing white Solid white
"Bluetooth"
mode
Flashing blue
or solid blue
(depending
on Bluetooth
connection
status)
Flashing blue
or solid blue
(depending
on Bluetooth
connection
status)
Turn on/off
• To turn the speaker on, slide the
OFF/AUDIO IN/ switch to or AUDIO
IN.
• : Listen to an external Bluetooth
device through Bluetooth connection.
• AUDIO IN: Listen to an external
device through an audio input cable.
• To turn the speaker off, slide the switch to
OFF.
6EN
4 Play
Play from Bluetooth devices
With this speaker, you can listen to audio from
Bluetooth-enabled devices.
Play from Bluetooth devices
Note
• Make sure that your Bluetooth device is compatible
with this speaker.
• Before pairing a device with this speaker, read its user
manual for Bluetooth compatibility.
• The speaker can memorize a maximum of 4 paired
devices.
• Make sure that Bluetooth function is enabled on your
device, and your device is set as visible to all other
Bluetooth devices.
• Any obstacle between this speaker and a Bluetooth
device can reduce the operational range.
• Keep away from any other electronic device that may
cause interference.
• The operational range between this speaker and a
Bluetooth device is approximately 10 meters (30 feet).
1 Slide the OFF /AUDIO IN/ switch to .
» TheLEDindicatorashesblue.
2 On your Bluetooth device, enable
Bluetooth and search for Bluetooth devices
that can be paired (refer to the user
manual of the device).
3 When [Philips BT2000] is displayed on
your device, select it to start pairing and
connection. If necessary, input “0000” as
the pairing password.
» After successful connection, the
speaker beeps twice, and the LED
indicator turns solid blue.
4 Play audio on the Bluetooth device.
» Audio streams from your Bluetooth
device to the speaker.
To disconnect the Bluetooth-enabled device:
• Press and hold PAIRING for two seconds;
• Disable Bluetooth on your device; or
• Move the device beyond the
communication range.
» TheLEDindicatorashesblue.
To reconnect the Bluetooth device:
• Next time you turn on the speaker, the
speaker will reconnect the last connected
device automatically; or
• On your Bluetooth device, select "Philips
BT2000" on your Bluetooth menu to start
connection.
To connect another Bluetooth-enabled device:
1 Press and hold PAIRING for two seconds
to disconnect the currently connected
device;
» The speaker enters Bluetooth pairing
mode.
2 Connect another Bluetooth device.
LED indicator Description
Flashing blue Connecting;
Waiting for pairing
Solid blue Connected
Play from external devices
With this speaker, you can also listen to an
external audio device such as an MP3 player.
1 Connect an audio input cable (not
supplied) with a 3.5 mm connector on
both ends to
• the AUDIO IN socket on this speaker,
and
• the headphone socket on the external
device.
7EN
2 Slide the OFF /AUDIO IN/ switch to
AUDIO IN.
» The LED indicator becomes white.
3 Play audio on the external device (refer to
its user manual).
Fold or unfold the speaker
• To achieve better bass effect, unfold the
speaker as illustrated.
• To make the speaker smaller, fold the
speaker.
Adjust volume
During play, use the volume control on your
Bluetooth or external device to adjust volume.
AUDIO-IN
8EN
5 Product
information
Note
• Product information is subject to change without prior
notice.
Specications
Amplier
Rated Output Power 2 W RMS
Frequency Response 80 -16000 Hz,
±3 dB
Signal to Noise Ratio >70 dBA
Audio-in Input 300mV RMS
Speaker
Speaker Impedance 4 ohm
Speaker Driver 4.5 cm full range
Sensitivity >81dB/m/W±3dB/m/W
Bluetooth
Bluetooth Version V3.0
BluetoothProle A2DP, AVRCP
Bluetooth Frequency
Brand
2.4 GHz ~ 2.48 GHz
Bluetooth Range 10 m (Free space)
General information
Power Supply (through
USB socket)
5 V 0.5 A
Built-in Battery Li-polymer battery
(3.7 V, 500 mAh)
Dimensions - Main
Unit (W x H x D)
99 x 77 x 93 mm
Weight - Main Unit 0.15 kg
9EN
6 Troubleshooting
Warning
• Never remove the casing of this device.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
device, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips Web page (www.
philips.com/support). When you contact Philips,
make sure that the device is nearby and the
model number and serial number are available.
General
No power
• Recharge your speaker.
No sound or poor sound
•Adjust volume on the connected device.
No response from the speaker
•Restart the speaker.
About Bluetooth device
The audio quality is poor after connection
with a Bluetooth-enabled device.
•The Bluetooth reception is poor. Move the
device closer to this product or remove
any obstacle between them.
Fail to nd [Philips BT2000] on your device
for pairing.
•Press and hold PAIRING for three seconds,
and then try again.
Cannot connect with the device.
•The Bluetooth function of the device is not
enabled. Refer to the user manual of the
device for how to enable the function.
•This product is already connected with
another Bluetooth-enabled device.
Disconnect that device and then try again.
The paired device connects and disconnects
constantly.
•The Bluetooth reception is poor. Move the
device closer to this product or remove
any obstacle between them.
•For some devices, Bluetooth connection
may be deactivated automatically as a
power-saving feature. This does not indicate
any malfunction of this product.
10 EN
7 Notice
Anychangesormodicationsmadetothis
device that are not expressly approved by
WOOX Innovations may void the user’s
authority to operate the equipment.
Notice for the USA and Canada
This device complies with Part 15 of the FCC
Rules and license-exempt RSS standard of
Industry Canada. Operation is subject to the
following two conditions:
1 this device may not cause harmful
interference, and
2 this device must accept any interference
received, including interference that may
cause undesired operation.
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses, and can radiate radio frequency energy
and, if not installed and used in accordance
with the instruction manual, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the
equipment off and on, the user is encouraged
to try to correct the interference by one or
more of the following measures:
• Relocate the receiving antenna.
• Increase the separation between
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
RF Radiation Exposure Statement: This
equipment complies with FCC’s and IC’s RF
radiation exposure limits set forth for an
uncontrolled environment. The antenna(s)
used for this transmitter must be installed and
operated to provide a separation distance of
at least 20 cm from all persons and must not
be collocated or operating in conjunction with
any other antenna or transmitter. Installers must
ensure that 20cm separation distance will be
maintained between the device (excluding its
handset) and users.
CAN ICES-3(B)/NMB-3(B)
Care of the environment
Disposal of your old product and battery
Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused.
This product may contain lead and mercury.
Disposal of these materials may be regulated
due to environmental considerations. For
disposal or recycling information, please contact
your local authorities or visit www.recycle.
philips.com.
This product contains non-removable batteries:
• Do not incinerate. Batteries may explode if
overheated.
• For disposal or recycling information,
please contact your local authorities or visit
www.recycle.philips.com.
Caution
• Removal of the built-in battery invalidates the warranty
and may destroy the product.
11EN
Always bring your product to a professional to
remove the built-in battery.
Environmental information
All unnecessary packaging has been omitted.
We have tried to make the packaging easy to
separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene
(bags, protective foam sheet.)
Your system consists of materials which can
be recycled and reused if disassembled by
a specialized company. Please observe the
local regulations regarding the disposal of
packaging materials, exhausted batteries and old
equipment.
Trademark notice
The Bluetooth® word mark and logos are
registered trademarks owned by Bluetooth
SIG, Inc. and any use of such marks by WOOX
Innovations is under license.
Specications are subject to change without notice.
2015 © WOOX Innovations Limited. All rights reserved.
This product was brought to the market by WOOX Innovations Limited or one of its affiliates,
further referred to in this document as WOOX Innovations, and is the manufacturer of the product.
P&F is the warrantor in relation to the product with which this booklet was packaged.
Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V.
BT2000_37_UM_V1.0