Table of Contents
APC ER7HCM User Manual
Displayed below is the user manual for ER7HCM by APC which is a product in the Rack Accessories category. This manual has pages.
Related Manuals
Installation 990–91454 Release date: 02/2021
Easy Rack 1U Horizontal Cable Manager ER7HCM
Kit Instructions
The 1U Horizontal Cable Manager is installed in a 1U space in the Easy Rack.
ER7HCM Inventory Tools required (not provided)
1U Horizontal Cable Manager (1)
Torx® wrench
M6 x 12 Pan Head T30 Screw (4)
Cage nut tool
Cage Nut M6 14/16 SWG (4)
Proper location in the rack for the cage nuts:
1U
7
6
5
ns0014a
1. Locate the top and bottom U space on the
vertical mounting rails. Every third hole on
the mounting rails is numbered to indicate
the middle of a U space.
2. Install the cage nuts on the interior of the
vertical mounting rail; then install the shelf.
APC by Schneider Electric
70 Mechanic Street
02035 Foxboro, MA
USA
www.apc.com
As standards, specifications, and design
change from time to time, please ask for
confirmation of the information given in this
publication.
© – 2021 APC by Schneider Electric. All rights
reserved.
Easy Rack 1U Horizontal Cable Manager ER7HCM
CAUTION
FALLING EQUIPMENT HAZARD
Do NOT install cage nuts vertically with the tabs engaging the top and bottom of
the square hole.
Failure to follow these instructions can result in injury or equipment
damage.
• Install cage nuts horizontally, with the tabs engaging
the sides of the square hole.
• Install the cage nuts on the interior of the vertical
mounting rail.
ns1768a
Install the cage nut:
gen0188a
1. From the inside of the rack, insert the cage nut into
the square hole.
2. Hook one tab of the cage nut assembly through the
far side of the hole.
3. Place the cage nut tool on the other side of the cage
nut and pull to snap into position.
Remove the cage nut:
1. Remove any attached screw.
2. Grasp the cage nut, squeeze the tabs on the sides, and push to release it from the square hole.
Install the Horizontal Cable Manager:
Using the hardware provided, install the four (4)
cage nuts in the vertical mounting rails of your
Easy Rack.
Use the four (4) M6 x 12 Pan head T30 screws
to secure the Horizontal Cable Manager to the
cage nuts.
2 990–91454