Table of Contents
APC ER7PDUBRKTS User Manual
Displayed below is the user manual for ER7PDUBRKTS by APC which is a product in the Mounting Kits category. This manual has pages.
Related Manuals
Installation 990–91479 Release date: 02/2021
Easy Rack Single Mounting Bracket Kit
ER7PDUBRKTS
Kit Instructions
The Single Mounting Brackets are used to mount a Rack PDU or other equipment
to the vertical mounting rails inside the rack. The location of the Mounting Brackets
depends on the equipment you want to install. The Mounting Brackets have cut
outs to accommodate the toolless mounting pegs of a Rack PDU.
ER7PDUBRKTS Inventory Tools required (not provided)
Single PDU Bracket
(2 Left and 2 Right)
Torx® wrench
M6 x 12 Pan Head T30 Screw (40)
Cage nut tool
Caged Nut M6 14/16 SWG (40)
Proper location in the rack for the cage nuts:
1. Locate the top and bottom U space on the
vertical mounting rails. Every third hole on
the mounting rails is numbered to indicate
the middle of a U space.
2. Install the cage nuts on the interior of the
vertical mounting rail; then install the shelf.
1U
7
6
5
ns0014a
APC by Schneider Electric
70 Mechanic Street
02035 Foxboro, MA
USA
www.apc.com
As standards, specifications, and design
change from time to time, please ask for
confirmation of the information given in this
publication.
© – 2021 APC by Schneider Electric. All rights
reserved.
Easy Rack Single Mounting Bracket Kit ER7PDUBRKTS
CAUTION
FALLING EQUIPMENT HAZARD
Do NOT install cage nuts vertically with the tabs engaging the top and bottom of
the square hole.
Failure to follow these instructions can result in injury or equipment
damage.
• Install cage nuts horizontally, with the tabs engaging
the sides of the square hole.
• Install the cage nuts on the interior of the vertical
mounting rail.
ns1768a
Install the cage nut:
gen0188a
1. From the inside of the rack, insert the cage nut into the
square hole.
2. Hook one tab of the cage nut assembly through the far
side of the hole.
3. Place the cage nut tool on the other side of the cage
nut and pull to snap into position.
Remove the cage nut:
1. Remove any attached screw.
2. Grasp the cage nut, squeeze the tabs on the sides, and push to release it from the square hole.
Install the Mounting Brackets:
Using the hardware
provided, install the
Mounting Brackets in the
location where you plan to
install your Rack PDU or
other equipment. There are
four Mounting Brackets in
the Kit; two (2) for the left
side of the rack and two (2)
for the right side of the rack.
Make sure to position the
Mounting Brackets so that
the small end of the cut out is
at the bottom so the toolless
mounting peg of a Rack PDU
installs securely.
The Easy Rack in the
illustration is shown without
doors or side panels for
clarity.
2 990–91479