Contour Design Unimouse R User Manual
Displayed below is the user manual for Unimouse R by Contour Design which is a product in the Mice category. This manual has pages.
Related Manuals
Product Manual
Wired
Unimouse Wired
Box Contents
1. Unimouse
2. User Guide
/1
1
2
Unimouse Wired
Unimouse Functions
For additional mouse features and specic
Mac settings, please download our driver at
contour-design.co.uk/support
/2
* See page 4
Auto scroll
Left click
Middle click*
Right click
Base/tilt
Wire
Back button
Forward button
Thumb rest
Cursor speed adjustment (DPI)
Cursor speed(LED)
Unimouse Wired
Connecting to a Computer
Plug the wireless receiver or the charging cable into the computer’s USB port.
Allow your computer a few seconds to automatically install.
/3
Middle Click to Double Click
Unimouse comes with middle click as the default setting. To change the middle
click function to double click, hold down the cursor speed button and the mid-
dle click at the same time. To switch back, repeat the same command.
Middle click / Double click
Cursor speed (DPI)
Unimouse Wired
Click Force
Tension
Adjustment
HighLow
/4
Adjust tilt for
desir ed angle
Thumb rest can pivot
to optimal position
Adjust thumb rest in and
out to accommodate
hand size
Slide thumb rest side to
side to a ccommodate
thumb lengt h
Adjustable Features
Unimouse Wired /5
Change cursor speed
Press the Cursor Speed button to cycle through cursor speeds. There are ten
speed selections ranging from slow (800 DPI) to fast (2800 DPI). Speed is
indicated by the LED lights as shown.
1) 800 2) 1000 3) 1200 4) 1400 5) 1600
6) 1800 7) 2000 8) 2200 9) 2400 10) 2800
FCC Statement
Changes or modications not expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
IC Statement
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
The term “IC: “ before the certication/registration number only signies that the Industry Canada technical specications were met. This
product meets the applicable Industry Canada technical specications.
Le présent appareil est conforme aux CNR d’Industrie Canada applicable aux appareils radio exempts de licence. L’exploitation est autorisée
aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage,
et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement
For more information please visit:
www.contour-design.co.uk
Kingsbury House
468 Church Lane
London, NW9 8UA
United Kingdom
Phone: +45 70 27 02 27
Email: info@contour-design.com
Tested to comply with FCC
and IC standards
Warranty
If there is a functional defect due to faulty manufacturing, we will replace the product. This warranty does not cover
damage that results from misuse of the product.
Attention!
If you attempt to dismantle your Unimouse, you will invalidate your warranty.