Intellinet 713252 User Manual
Displayed below is the user manual for 713252 by Intellinet which is a product in the Rack Cabinets category. This manual has pages.
Related Manuals
Server & Network
Cabinets
Assembly Instructions
SNCAB-INST-ICG-0915-01
Front Door
Side
Panel
Rear Panel
Bottom Cover Adjustable Feet
Top Cover
Attach the Adjustable Feet to the Bottom Cover
Set the
Vertical
Proles
on the
Bottom
Cover
Insert each
prole as
shown
Secure
the Vertical
Proles on
the inside
using M5x12
Phillips-head
screws
Note: Cable
entry is at
the rear
Do not
overtighten:
It can damage
the screws
3
2
1
Rear
Front
Front
Tools Needed
* Steps 10-12 are for 600mm-wide cabinets. For cabinets
that are 800 mm wide, jump to Step 13.1.
Caution: The mounting rails are attached to the cabinet at
3 points: Be sure they are a safe distance from the door.
5Secure the Top Cover from both sides
Use M5x12
Torx-head
screws
Attach
the Rear
Panel
Locking
Points
Use M5x12
Phillips-head
screws
6
7
Use
M5x12
Torx-head
screws
Attach
both
Side
Support
Rails
Use M5x12
Torx-head
screws
8
10
11
To install the Back Panel,
rst insert the tabs in the
Bottom Cover slots
9.
1
Set the locks in
the unlock position
9.
2
9.
3
Turn
the locks
to the lock
position
Use M5x12
Torx-head screws
Attach the 19”
Mounting Rails
for cabinets
600 mm wide*
Attach the
Mounting Rails to
the Bottom Cover
Use M5x12
Torx-head
screws
Attach the
Rear Panel
Supports
Set the Rear Panel
in place
* Steps 13.1 & 13.2 are for
800mm-wide cabinets.
13.1 Attach a pair of adapters to
each side support rail (on
the left and right sides of
the cabinet interior).
13.2 Attach the mounting rails:
• First, to the adapter
• Next, to the bottom cover
• Then, to the top cover
12 Attach the Mounting Rails
to the Top Cover
Attach the
Mounting Rails
to the Adapters
Use
M5x12
Torx-head
screws
1
3.1
Attach
the Adapters
for cabinets
800 mm wide*
Use M5x12
Torx-head screws
1
3.1
Repeat
Steps
9.1-9.3
for the
side
panels
Attach the Side Panels
14
Attach the Door
15
Set the
washer
between the
door pin and
bottom cover
Pull down the latch
to set the door
in place
1
3.2
Rear
Front
Set the Top Cover on the Vertical Proles
4
Note:
Cable entry
is at the
rear