Philips DMRC210 User Manual
Displayed below is the user manual for DMRC210 by Philips which is a product in the Lighting Accessories category. This manual has pages.
Related Manuals
DMRC210
X 2
240 mm (9.44 in)
38 mm (1.49 in)
45 mm (1.77 in)
230 mm (9.05 in)
1 2
Relay Controller
www.lighting.philips.com/dynalite
Installation Instructions
Instructions d’installation
Installationsanweisungen
Instrucciones de instalación
Istruzioni per l’installazione
Installatie-instructies
インストー ル 手 順
安装指示
50° C (122° F)
0° C (32° F)
≤
90%
Devices must be installed by a
qualied electrician in accordance with
all national and local electrical and
construction codes and regulations.
Les appareils doivent être installés par un
électricien diplômé conformément à tous les
codes et réglementations électriques et de
construction nationaux et locaux.
Die Geräte sind von einem qualizierten Elektriker
in Übereinstimmung mit allen geltenden
Vorschriften zu installieren.
Los dispositivos deben ser instalados por un
electricista calicado y cumpliendo todas las
normas y regulaciones, tanto nacionales como
locales, sobre instalaciones eléctricas y obras.
I dispositivi devono essere installati da un
elettricista qualicato in conformità con le norme
locali e nazionali vigenti in materia di costruzioni
edilizie e installazione di impianti elettrici.
De apparaten moeten worden aangebracht
door een gekwaliceerde elektricien en in
overeenstemming met alle nationale en
plaatselijke elektriciteits- en bouwvoorschriften.
装置を取り付ける際は、資格のある電気技師に依頼し、
国および地域の電気および建設に関するすべての法令に
従 ってくだ さい 。
根据国家/地区及当地的电气与建筑规范和法规，该设
备必须由有资质的电工进行安装。
.
30 mm (1.18 in)
30 mm (1.18 in)
30 mm (1.18 in)
30 mm (1.18 in)
3
DyNet RS-485
8
N
20A
Lin
Lout2
Lout1
N
N
DyNet
RS-485
Shield
D-
+12 V
D+
GND
SHLD
≤ 5 mm2
10+ AWG
0.62 Nm
5.5 Lb-in
≤ 2 A
≤ 2.5 mm2
12+ AWG
0.4 Nm
3.5 Lb-in
Output Ratings/Channel (CH)
General Use
Load Type CH1-CH2
10 A, 240 V
5 A, 240 V
3 A, 240 V
165 A
Incandescent
Electronic Ballast
Inrush Current
Output Ratings/Group
DMRC210 ≤ 20 A
100-240 V
20 A
Lin
Lout1
Lout2
N
µP
N
DyNet RS-485
+12 V
D +
D -
GND
SHLD
12 V
150 mA
4
6
7
5
9
IEC Overvoltage Category III
IEC Pollution Degree II
AZZ 381 0718 R12
© 2019 Signify Holding. All rights reserved. Specications are subject to
change without notice. No representation or warranty as to the accuracy or
completeness of the information included herein is given and any liability
for any action in reliance thereon is disclaimed. Philips and the Philips
Shield Emblem are registered trademarks of Koninklijke Philips N.V. All other
trademarks are owned by Signify Holding or their respective owners.
www.lighting.philips.com/dynalite