Table of Contents
Vaddio 998-2225-152 User Manual
Displayed below is the user manual for 998-2225-152 by Vaddio which is a product in the Video Conferencing Accessories category. This manual has pages.
Related Manuals
Document Number 411-0018-31 Rev A – November 2017
Installation Guide
Hard Ceiling Mounting Kit for DocCAM 20 HDBT
Part Number 998-2225-152
Before you start, please refer to the camera's installation guide for connection diagrams and additional information
on testing and installing the camera. This guide only covers physical installation using kit 998-2225-152.
What's Included
nMounting plates (2)
nFlat-head machine screws, black (4)
nScrew anchors (4)
n1 1/4 in. screws (4)
nFlat-head machine screws, white (2)
nLarge trim ring – OD 12.25 in. (311 mm), depth 0.58 in (8.5 mm)
Things You Will Need for the Installation
Before you start, be sure you have what you need:
nAccess to the area above the ceiling
nPlumb line
nPencil
nAppropriate tools for cutting a hole in the ceiling
n#2 Phillips screwdriver
nConduit box, if required
Preparing the Hard Ceiling
Note
All above-ceiling work must conform to local building codes and should be performed by qualified personnel.
1. Determine the exact alignment of the camera with respect to the subject. The
camera face with the connector must point in the same direction as the top of
the document or other camera subject.
Note
The image cannot be rotated. Ensure that the camera is aligned precisely.
2. Trace a square, 8.125 x 8.125 inch (20.7 x 20.7 cm), for the camera opening.
3. Cut the camera opening.
Completing the Installation in a Hard Ceiling
1. Attach the mounting plates to the camera with the black machine screws.
2. Lift the camera into place and mark the locations to drill into the ceiling.
3. Drill the holes and install the screw anchors.
4. Connect the camera cable to the camera, routing it through a conduit box if required.
5. Lift the camera into place and secure it with the 1 1/4 in. screws.
6. Attach the trim ring to the camera's bezel ring with the white machine screws.
7. Connect the camera cable to the PoE+ injector or the OneLINK device, as applicable.
Installation Guide for the Hard Ceiling Mounting Kit for DocCAM 20 HDBT